AirTouch F20 Complete Mask System

Resmed UltraSoft™ memory foam cushion is super soft and uniquely comfortable

Magnetic clips mean two simple snaps and your mask is on or off

Quick-release elbow allows you to get up at night and disconnect without removing the mask

Soft and flexible frame sits underneath the eyes and adapts to different facial types, while integrated
padding adds softness

Diffused venting evenly disperses air and dampens air flow

Note: to use this mask with AirMini the F20 set up pack is required. If you are currently using the AirMini with a different style mask, then you will need to purchase the F20 Mask Connector

Prescription required 

F20 frame system (includes frame, soft sleeves, cushion and elbow)

F20 standard headgear with clips (other sizes available for purchase)

Cleaning the cushion

You do not need to clean the cushion every day. If any visible deterioration of the cushion is apparent, the cushion should be discarded and replaced.
If required, wipe the outside of the foam cushion with CPAP wipes or similar alcohol-free wipes and allow to dry.
Do not rinse or submerge in liquid
Do not expose to domestic cleaning products or cleaning devices
Do not store or place in direct sunlight.

Cleaning the frame and elbow

Daily:

1. Disassemble the mask components according to the disassembly instructions.
2. Rinse the frame and elbow under running water.
3. Clean with a soft brush until dirt is removed.
4. Soak the components in warm water (approximately 86°F/30°C) with a mild liquid detergent for up to ten minutes.
5. Shake the components vigorously in the water for at least one minute.
6. Brush the moving part of the elbow and around the vent holes.
7. Brush the areas of the frame where the arms connect, and inside and outside the frame where the elbow connects.
8. Rinse the components under running water.
9. Leave the components to air dry out of direct sunlight. Make sure to squeeze the arms of the frame to ensure excess water is removed.

Cleaning the headgear

Weekly:

1. Disassemble the mask. The magnets can remain attached to the headgear during cleaning.
2. Handwash the headgear in warm water (approximately 86°F/30°C) with mild liquid detergent.
3. Rinse the headgear under running water. Inspect to ensure the headgear is clean and detergent free. Wash and rinse again if necessary.
4. Squeeze the headgear to remove excess water.
5. Leave the headgear to air dry out of direct sunlight

Recommended replacement guidelines:

Cushion: every two (2) weeks

Frame: every three (3) months

Headgear: every six (6) months

Fitting Guide

User Guide

The mask contains magnets that may interfere with certain implants or medical devices. Please refer to the support documents for complete labeling information, including magnet contraindications and warnings.