AirFit N20 Complete Mask System

InfinitySeal™ cushion is designed to stay sealed at any airflow pressure setting

Magnetic clips mean two simple snaps and your mask is on or off

Quick-release elbow allows you to get up at night and disconnect without removing the mask

Plush headgear and soft, flexible frame provide added comfort

Note: to use this mask with AirMini the N20 set up pack is required. If you are currently using the AirMini with a different style mask, then you will need to purchase the AirFit N20 Mask Connector

Prescription required

N20 frame system (includes frame, cushion and elbow with short tube)

N20 standard headgear with clips (other sizes available for purchase)

Regularly clean your mask and its components to maintain the quality of your mask and to prevent the growth of germs that can adversely affect your health

Daily/After each use: cushion, elbow and short tube

1. Soak and agitate the AirFit N20 cushion, elbow and short tube in warm water (approximately 86°F/30°C) using a mild liquid detergent for up to 10 minutes.
2. Clean the components with a soft bristle brush, paying particular attention to the small vent holes on the elbow.
3. Thoroughly rinse the components under warm flowing drinking quality water.
4. Inspect each component to ensure that they are visually clean and free of detergent residue. If required, repeat washing.
5. Allow the components to dry out of direct sunlight before assembling.

Weekly: headgear and frame

The magnetic clips on the frame can be left on for washing.

1. Soak and agitate the separated headgear and frame in warm water (approximately 86°F/30°C) using a mild liquid detergent for up to 10 minutes.
2. To rinse the components, repeatedly squeeze them under warm flowing drinking quality water until it is free of detergent residue.
3. Squeeze the components to remove excess water.
4. Allow the components to dry out of direct sunlight before assembling

Recommended replacement guidelines:

Cushion: once (1) monthly

Frame System: every three (3) months

Headgear: every six (6) months

User Guide

Fitting Guide

The mask contains magnets that may interfere
with certain implants or medical devices. Please refer to the support documents for complete labeling information,including magnet contraindications and warnings.

Shipping method

Ground - $5.00 - 5 to 8 business days

Ground order over $50 Free - 5 to 8 business days

Express - $15.00 - 2 to 3 business days

Express orders including PAP device(s)*** Free - 2 to 3 business days

Priority Express $40.00 - 1 to 2 business days

*All rates are shown in US Dollars and subject to change
**Expedite may substitute another carrier at our discretion
***Orders that include the purchase of a PAP device

Delivery will be to the address specified on your order, which must be within the United States and in a state where Expedite is licensed to distribute medical devices. We do not deliver to PO boxes.

The delivery charges specified as part of your order for your selected shipping will apply. Delivery charges will be disclosed in your cart prior to you placing your order.

Once your order has been shipped from our warehouse, you will receive an automated email with the invoice and tracking reference, allowing you to track your order. Title to Products and risk of loss shall pass to you upon delivery of Products to the carrier at the point of shipment.

We take reasonable efforts to meet the delivery times specified in this section. However, occasionally delivery times may be affected by factors beyond our control and therefore they cannot be guaranteed.

You must comply with all applicable laws and regulations of the United States. We will not be liable or responsible if you break any such law.