AirTouch N20 Complete Mask System

Resmed UltraSoft™ memory foam cushion is uniquely comfortable

Magnetic clips mean two simple snaps and your mask is on or off

Quick-release elbow allows you to get up at night and disconnect without removing the mask

Minimal cleaning requirements give you time back in the morning

The mask frame is designed to also work with the Resmed AirFit™ N20 silicone cushion

Note: to use this mask with AirMini the N20 set up pack is required. If you are currently using the AirMini with a different style mask, then you will need to purchase the N20 Mask Connector

Prescription required

N20 frame system (includes frame, cushion and elbow with short tube)

N20 standard headgear with clips (other sizes available for purchase)

Elbow and short tube (Daily/After each use)

1. Soak and agitate the elbow and short tube in warm water (approximately 86°F/30°C) using a mild liquid detergent for up to 10 minutes.
2. Clean the components with a soft bristle brush, paying particular attention to the small vent holes on the elbow.
3. Thoroughly rinse the components under warm flowing drinking quality water.
4. Inspect each component to ensure that they are visually clean and free of detergent residue. If required, repeat washing.
5. Allow the components to dry out of direct sunlight before assembling.

Headgear, frame (Weekly)

The magnetic clips on the frame can be left on for washing.
1. Soak and agitate the separated headgear and frame in warm water (approximately 86°F/30°C) using a mild liquid detergent for up to 10 minutes.
2. To rinse the components, repeatedly squeeze them under warm flowing drinking quality water until it is free of detergent residue.
3. Squeeze the components to remove excess water.
4. Allow the components to dry out of direct sunlight before assembling.

AirTouch N20 cushion (as required)
The cushion must not be submerged in liquid as this may damage the cushion and affect mask performance.
Discard the cushion if it is submerged in liquid or heavily soiled.
Do not expose the cushion to domestic cleaning products or cleaning devices.
You do not need to clean the AirTouch N20 cushion every day. It is recommended to replace your cushion every month. If any visible deterioration of the cushion is apparent, the cushion should be discarded
and replaced. If required, wipe the outside of the foam cushion with CPAP wipes or similar alcohol-free wipes and allow to dry. Do not store or place the cushion in direct sunlight

Recommended replacement guidelines:

Cushion: once (1) monthly

Frame: every three (3) months

Headgear: every six (6) months

Fitting Guide

User Guide

The mask contains magnets that may interfere with certain implants or medical devices. Please refer to the support documents for complete labeling information, including magnet contraindications and warnings.