AirFit F40 Complete Mask System

Lower profile design in a full face mask

Soft silicone AdaptiSeal™ for softness

Fully flexible frame for comfort

Four adjustment points for ease of use

Quick-release elbow for fast connection and disconnection

Combines high seal performance with comfort in a minimalist, flexible and easy-to-use design

Short tube for natural movement

A soft, fully flexible frame adapts to the face all night long

Note: this mask is not compatible with the AirMini

Prescription required

F40 headgear (small, standard or large)

F40 mask frame (small-wide, medium or large)

F40 cushion (small-wide, medium or large)

If there is any visible deterioration of a mask component (cracking, crazing, tears etc.) the component should be discarded and replaced.

Daily/After each use: Cushion, elbow and short tube, vent ring

Weekly: Headgear, frame
1. Soak the components in warm water with a mild liquid detergent. Ensure that there are no air bubbles while soaking.
2. Shake the components vigorously in the water and hand wash with a soft bristle brush. Pay particular attention to the vent holes in the QuietAir/Multi-hole vent ring.
3. Thoroughly rinse the components under running water.
4. Squeeze the fabric components to remove excess water.
5. Leave the components to air dry out of direct sunlight. If the mask components are not visibly clean, repeat the cleaning steps. Make sure that the vents and anti-asphyxia valves are clean and clear.

Recommended replacement guidelines:

Cushion: once (1) monthly

Frame: every three (3) months

Headgear: every six (6) months

User Guide

Fitting Guide

The mask contains magnets that may interfere with certain implants or medical devices. Please refer to the support documents for complete labeling information, including magnet contraindications and warnings.